Description
The WAGO 789-622 current signal conditioner features Current input signal: 50 AAC, Modbus RTU, Supply voltage: 24 VDC, Module width: 35 mm.
Specifications
- Input signal type: Current
- Resolution [bit]: 14 Bit
- Measured variable: Current
- Input signal (current): 0 … 50 AAC
- Number of devices (max.): 32
- Connector: RJ-45
- Bus length (max.): 1200 m
- Terminating resistor: 150 Ω (can be activated via DIP switch 1)
- Communications: Modbus RTU
- Interface: RS-485
- Transmission channels: Half duplex; 8-bit data; 1 stop bit
- Parity: Even
- Bus length (max.): ≤ 1200 m
- Transmission rate: 19.2 kBd
- Transmission error (typ.): 1 % (typ.); 3 % (max.) of upper-range value (at room temperature)
- Temperature coefficient: ≤ 0.01 %/K
- Nominal supply voltage US: 24 VDC
- Current consumption at nominal supply voltage: ≤ 8 mA
- protection rating: IP20
- Connection Data — Feedthrough for measurement conductor: Ø 15 mm
- Connection Data — Connector: RJ-45
- Width: 35 mm / 1.378 inches
- Height: 90 mm / 3.543 inches
- Depth from upper-edge of DIN-rail: 55 mm / 2.165 inches
- Mounting type: DIN-35 rail
- Housing design: DIN-rail-mount enclosure
- Weight: 62.6 g
- Ambient temperature (operation): -20 … +70 °C
- Ambient temperature (storage): -40 … +85 °C
- Conformity marking: CE
- EMC immunity to interference: EN 61000-6-2
- EMC emission of interference: EN 61000-6-4
- Standards/specifications: DIN EN 50178
Image shown is representative. Refer to the product specifications for the exact configuration.