Description
The WAGO 789-621 current signal conditioner features Current input signal: 140 ADC, Modbus RTU, Supply voltage: 24 VDC, Module width: 35 mm.
Specifications
- Input signal type: Current
- Resolution [bit]: 15 Bit
- Measured variable: Current
- Input signal (current): 0 … 140 ADC
- Number of devices (max.): 32
- Connector: RJ-45
- Bus length (max.): 1200 m
- Terminating resistor: 150 Ω (can be activated via DIP switch 1)
- Communications: Modbus RTU
- Interface: RS-485
- Transmission channels: Half duplex; 8-bit data; 1 stop bit
- Parity: Even
- Bus length (max.): ≤ 1200 m
- Transmission rate: 19.2 kBd
- Transmission error (typ.): ≤ 0.5 % of upper-range value (0 … 80 A; at room temperature); ≤ 1 % of upper-range value (80 … 140 A; at room temperature)
- Temperature coefficient: ≤ 0.05 %/K (-20 … 60 °C); ≤ 0.1 %/K (60 … 70 °C)
- Nominal supply voltage US: 24 VDC
- Current consumption at nominal supply voltage: ≤ 8 mA
- protection rating: IP20
- Connection Data — Feedthrough for measurement conductor: Ø 15 mm
- Connection Data — Connector: RJ-45
- Width: 35 mm / 1.378 inches
- Height: 90 mm / 3.543 inches
- Depth from upper-edge of DIN-rail: 55 mm / 2.165 inches
- Mounting type: DIN-35 rail
- Housing design: DIN-rail-mount enclosure
- Weight: 77.4 g
- Ambient temperature (operation): -20 … +70 °C
- Ambient temperature (storage): -40 … +85 °C
- Conformity marking: CE
- EMC immunity to interference: EN 61000-6-2
- EMC emission of interference: EN 61000-6-4
- Standards/specifications: DIN EN 50178
Image shown is representative. Refer to the product specifications for the exact configuration.