Liquid-tight cordgrip made from nickel plated brass
Used where cable is entering or leaving an enclosure.
Accepts a wide range of cable diameters due to large opening and NBR (nitrile rubber) seal.
The strain relief elements tighten in a circular sequence on the sealing ring to give outstanding strain relief without twisting or damaging the cable.
Use the cordgrip with the smallest maximum diameter that will fit your application (see table below).
Locknut and EPDM o-ring included (as shown).
Designed to meet NEMA Type 4, 4X, 6, 6P, 12 & 13 - Protection to IP68.
-40C to + 100C working temp with a temporary heat resistance up to 120C.
